2006 Arctic Cat ATVs factory service and repair manual, Page 61Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 61

B AT THIS POINT To service center crankcase components only, oroceed to Removina Left-Side Comoonents Left-Side Components
securing the starter to the crankcase; then remove the starterRemove the four cap screws securing the recoil cover to the
left-side cover; then remove recoil coverA CAUTION Do not allow the connecting rod to go down inside the crankcaseIf the
rod is down inside the crankcase and the crankshaft is rotated, severe damage will resultI NOTE: If the existing rings will
not be replaced with new rings, note the location of each ring for proper installationWhen replacing with new rings, replace
as complete set onlyIf the piston rings must be removed, remove them in this sequence AStarting with the top ring, slide
one end of the ring out of the ring-grooveBRemove each ring by working it toward the dome of the piston while rotating it
out of the grooveB AT THIS POINT To service piston, see Servicing Top-Side Components sub-section3-18 Page: 61 Arctic Cat
ATV 2006 -All Models 3Remove the flange nut securing the starter cup to the crankshaft; then remove the starter cupAccount