2006 Arctic Cat ATVs factory service and repair manual, Page 72Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 72

Remove the output shaft assembly (J)Remove the two shift shafts (E and H)Remove the reverse shift cam (G) and spacerDisengage
forks noting their positions for assembling purposesB AT THIS POINT To service gear shift forks, see Servicing Center Crankcase
Components sub-section 1 NOTE: Note that the shoulder of the gear is directed to the outside for assembling purposes 10Remove
the crank balancer assembly (A)When removing the crank balancer assembly, rotate the crankshaft counterweight away from the
crank balancer assembly counterweight1 NOTE: 7Remove the reverse idle gear (K) wlshaftAccount for the bushing, two washers,
and the circlip 8Simultaneously, remove the driveshaft assembly (I) and countershaft assembly (D)B AT THIS POINT see Servicing