2006 Arctic Cat ATVs factory service and repair manual, Page 74Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 74

2Place the valve cover on the Surface Plate (pln 0644-016) covered with #400 grit wet-or-dry sandpaperUsing light pressure,
valve seals must be replaced Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or
damageto the sealing surface mayresult: - 3Remove the valve springs; then invert the cylinder head and remove the valves
Measuring Valve Stem Runout Removing Valves 1 NOTE: Keep all valves and valve components as setNote the original location
of each valve set for use during installationReturn each valve set to its original location during installation 1Support
each valve stem end with the Blocks (pln 0644-022); then check the valve stem runout using dial indicator 1Using valve spring