2006 Arctic Cat ATVs factory service and repair manual, Page 75Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 75

Measuring Valve Stem Outside Diameter Measuring Valve GuideNaIve Stem Deflection (Wobble Method) 1Using micrometer, measure
Valve Face Radial Runout 4Maximum "wobble" deflection must not exceed specificationsMeasuring Valve Guide (Inside Diameter)
1Mount dial indicator on the surface plate; then place the valve stem on set of blocks2Position the dial indicator contact
point on the outside edge of the valve face; then zero the indicator 1Insert snap gauge 112 way down into each valve guide
bore; then remove the gauge and measure it with micrometer2Acceptable inside diameter range must be within specifications
3If valve guide is out of tolerance, it must be replacedReplacing Valve Guide WNOTE: If valve guide is worn or damaged, it
must be replaced 1If valve guide needs replacing, insert valve guide remover into the valve seat side of the valve guideUsing