2006 Arctic Cat ATVs factory service and repair manual, Page 81Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 81

Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder
oilThoroughly clean cylinder after honing using soap and hot waterDry with compressed air; then immediately apply oil to
the cylinder boreIf the bore is severely damaged or gouged, replace the cylinder Inspecting Cam Chain Guide 1Inspect cam
chain guide for cuts, tears, breaks, or chips2If the chain guide is damaged, it must be replacedHoning Cylinder 1Using slide
gauge and dial indicator or snap gauge, measure the cylinder bore diameter in three locations from top to bottom and again
from top to bottom at 90 from the first measurements for total of six measurementsThe trueness (out-of-roundness) is the
difference between the highest and lowest readingMaximum trueness (out-of-roundness) must not exceed specifications 4If any