2006 Arctic Cat ATVs factory service and repair manual, Page 92Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 92

CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting rod
the surface platePosition the indicator contact point against the center of the connecting rod small end journal 2Zero the
indicator and push the small end of the connecting rod away from the dial indicator3Maximum deflection must not exceed specifica-
Measuring Connecting Rod (Big End Side-to-Side) 1Push the lower end of the connecting rod to one side of the crankshaft journal2Using
feeler gauge, measure the gap between the connecting rod and crankshaft journal3Zero the indicator and rotate the crankshaft
Iwhen rotatina the crankshaft Care should be taken to support the connecting rod 4Maximum runout must not exceed specifications1
NOTE: Proceed to check runout on the other end of the crankshaft by positioning the indicator contact at point and following