2006 Arctic Cat ATVs factory service and repair manual, Page 107Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 107

14Install the starter clutch shoe and washer; then secure with the starter clutch-shoe nut (left-hand threads)Tighten to
hub holder, install the nut and washerTighten to specifications1 NOTE: The washer is directionalCare must be taken to install
it correctly 15Install the release roller assembly making sure the four springs are in position; then using crisscross pattern,
tighten the four cap screws securely1NOTE: Tighten the four roller assembly cap screws in crisscross pattern making sure
there is no clearance between the clutch plates when secured 13Place the primary drive one-way clutch into the starter clutch