2006 Arctic Cat ATVs factory service and repair manual, Page 108Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 108

17Secure the clutch release arm with the cap screw coated with blue Loctite #243Tighten securely 19Tighten the cap screws
into position on the crankcase and secure with the cap screwsNote the position of the wiring form 1 NOTE: Care should be
taken that the alignment pins are installed in the right-side cover 18Place the gasket and right-side cover into position
making sure the release roller guide remains correctly positioned; then install the fifteen cap screws Place the neutral
switch base assembly into position making sure the two neutral contacts and springs are inside the case and properly positionedSecure