2006 Arctic Cat ATVs factory service and repair manual, Page 111Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 111

13Instal1 Ihe Iwo crankcase half pins into the left l NOTE: Make sure that three washers and two alignment pins are in place
gear match up during assembly 17On the FIS models, place the speed sensor into position and secure with the two cap screwsTighten
securely- 14Place the gasket and left-side cover into position on the crankcase1 NOTE: It may be necessary to push or pull
the splined HiILow range shift shaft to establish coverlcrankcase mating 15Install the fifteen mm cap screws and one mm cap
screw to secure the left-side coverOnly finger-tighten at this time 18Place the starter cup into position on the crankshaft