2006 Arctic Cat ATVs factory service and repair manual, Page 121Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 121

21Install the front and rear fender panels and the front and rear racks (see Section 8)22On VP models, install the gas tank
hole: install the filler plG w1a7 19Install the exhaust pipe and secure with two cap screws; then install the muffler onto
the frame brackets and secure with exhaust springs anual Transmission Level StickFiller Plug A CAUTION If the engine had
major overhaul or if any major part was replaced, proper engine break-in procedures must be followed (see Section 1)If the
proper engine break-in procedures are not followed, severe engine damage may result 20Connect the gas hose to the fuel pump;