2006 Arctic Cat ATVs factory service and repair manual, Page 122Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 122

Table of Contents (400 Automatic Transmission) 2Remove the negative cable from the battery; then remove the positive cableRemove
introducing each sub-section for this important informationSection 8) View from Beneath 6Remove the front and rear fender
panels (see B AT THIS POINT If the technician's objective is to servicelreplace left-side cover oil seals (3), front output
joint oil seal (I), rear output joint oil seal (I), andlor the oil strainer (from beneath the engine1 transmission), the
engineltransmission does not have to be removed from the frame 7On the VP models, turn the gas tank valve to the OFF position;
then remove the fuel hose and vent hoseOn the FIS models, disconnect the fuel hose (I), carburetor vent hose (2), and the
fuel pump vacuum hose (3) from the carburetor Secure the ATV on support stand to elevate the wheels port stand to avoid injury8Remove