2006 Arctic Cat ATVs factory service and repair manual, Page 124Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 124

18Remove the four cap screws securing the rear output shaft to the transmission; then push the shaft to the rear as far as
the speed sensor lead from the wiring harness24Remove the cap screw and flange nut securing the upper engine bracket to the
engine; then remove the bracket25Remove the spark plug wire from the spark plug26Remove the shift indicator connector from
the main wiring harness27Remove the cap screw securing the engine ground wire to the engine 2 1Disconnect the stator-to-rectifierlregulator