2006 Arctic Cat ATVs factory service and repair manual, Page 128Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 128

15Using Piston-Pin Puller (pln 0644-328), remove the piston pinAccount for the opposite-side circlipRemove the piston1 NOTE:
the rod is down inside the crankcase and the crankshaft is rotated, severe damage 1 NOTE: If the existing rings will not
be replaced with new rings, note the location of each ring for proper installationWhen replacing with new rings, replace
as complete set onlyIf the piston rings must be removed, remove them in this sequence When removing the cylinder, be sure
to support the piston to prevent damage to the crankcase and pis- 14Using an awl, remove one piston-pin circlipTake care
not to drop it into the crankcase AStarting with the top ring, slide one end of the ring out of the ring-groove Page: 128