2006 Arctic Cat ATVs factory service and repair manual, Page 141Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 141

3If valve guide is out of tolerance, it must be replacedReplacing Valve Guide rn NOTE: If valve guide is worn or damaged,
the dial indicator contact point against the outside edge of the valve faceZero the indicator2Using the Standard Valve Guide
Reamer (pln 0444-017)7remove any burrs or tight areas from the valve guide journals 3Push the valve from side to side; then
from top to bottom 4Maximum "wobble7' deflection must not exceed specificationsMeasuring Valve Guide (Inside Diameter) 3To
install valve guide, use valve guide installer and gently drive valve guide with retaining clip into the bore from the valve
spring side until the retaining clip just contacts the cylinder head 1Insert snap gauge 112 way down into each valve guide