2006 Arctic Cat ATVs factory service and repair manual, Page 146Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 146

Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or dam- Measuring Cylinder Head
not exceed specificationsCleaningllnspecting Cylinder 1Wash the cylinder in parts-cleaning solvent2Inspect the cylinder for
pitting, scoring, scuffing, warpage, and corrosionIf marks are found, repair the surface using cylinder hone (see Honing
Cylinder in this sub-section)3Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light
pressure, move the cylinder in figure eight motionInspect the sealing surface for any indication of high spotsA high spot
can be noted by bright metallic finishCorrect any high spots before assembly by continuing to move the cylinder in figure
eight motion until uniform bright metallic finish is attained 2 Wash the cylinder in parts-cleaning solvent 3Inspect the
cylinder for pitting, scoring, scuffing, and corrosionIf marks are found, repair the surface using ball hone Page: 146 Arctic