2006 Arctic Cat ATVs factory service and repair manual, Page 150Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 150

9Remove the spiral spring from the case by lifting the spring end up and outHold the remainder of the spring with thumbs
cracks, or deteriorationAssemblingllnstalling 1If removed, insert the spiral spring into the case with the outer end of the
spring around the mounting lug in the case; then wind it in counterclockwise direction until the complete spring is installed1NOTE:
The spiral spring must seat evenly in the recoil case IcaseWear safety glasses to avoid injury2Insert the rope through the
hole in the reel and tie knot in the end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm
(20 in of rope free of the reel 8Remove the protective cover from the starter handle and pull the rope out of the handle;
then untie the knot in the rope and remove the handlei NOTE: Do not remove the spiral spring unless replacement is necessaryIt