2006 Arctic Cat ATVs factory service and repair manual, Page 155Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 155

Assembling 1Place the fixed face of the driven pulley on the pulley compressor base making sure the dowel pins are engaged
the sleeve and into the spring anchor hole in the movable face 2Apply multi-purpose grease to the O-rings and grease seals
on the movable face; then install on the fixed face making sure the alignment marks are properly aligned 6Place the spring
holder on the spring engaging the spring end with the appropriate anchor hole 3Install the three pins and spacers into the
fixed face hub; then pack the cam slots in the movable face with multi-purpose grease 7Assemble the notched-ring nut, spring