2006 Arctic Cat ATVs factory service and repair manual, Page 160Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 160

CRANK BALANCER DRIVEN GEAR Assembling Crankcase :EY 12345Balancer Shaft Washer Driven GearDriven Gear #2 Spring 6Key 7Pin
and keyway for wear2Inspect the springs for damage or fatigueAssembling 1Place driven gear #2 into driven gear #l; then align
the alignment marks of driven gear #1 and driven gear #22Using pair of needle-nose pliers, insert each spring part way into
the slot; then install pin and push the springlpin assembly into the slot3Place the key and the large washer into position
on the balancer shaft 2Apply red Loctite #271 to the threads of the output shaftInstall and tighten the nut specificationsUsing
punch, peen the nut 4Place the driven gear #1 assembly onto the balancer shaft; then place the large and small washers onto