2006 Arctic Cat ATVs factory service and repair manual, Page 161Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 161

3Apply liberal amount of oil to the crankshaft bearingUsing propane torch, heat the bearing until the oil begins to smoke;
and snap ring1 NOTE: If heating the bearing is not possible, the crankshaft can be installed using crankshaft installer 4Rotate
the crankshaft so the counterweight is toward the rear of the engineInstall the counterbalance shaft 5Keeping the counterbalance
gear timing mark aligned with the one on the crankshaft gear, install the key and the counterbalance gear 8Install the outer