2006 Arctic Cat ATVs factory service and repair manual, Page 162Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 162

11Install the secondary and primary driveshaft assembliesAccount for the bearing alignment C-ring on the bearing boss next
Three Bond Sealant (pln 0636-070) to the mating surfacesPlace the right-side half onto the left-side half 10Install the washer,
spacer, sleeve, reverse idler gear, and washer 2Using plastic mallet, lightly tap the case halves together until cap screws
can be installed 3From the right side, install the crankcase cap screws noting the location of the different-sized cap screws;