2006 Arctic Cat ATVs factory service and repair manual, Page 166Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 166

Making sure the eight movable drive face rollers are in position, pinch the V-belt together near its center and slide the
separated, insert wedge (approximately 318 inthick) between the facesRelease the inner face 1NOTE: At this point, the wedge
can be removed from between the driven pulley faces 17Place the V-belt into position on the driven pulley and over the front
shaft Rotate the V-belt and driveldriven assemblies until the V-belt is flush with the top of the driven pulleyInstall two
alignment pins and place the V-belt cover gasket into position on the clutch coverInstall the V-belt cover noting the position