2006 Arctic Cat ATVs factory service and repair manual, Page 168Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 168

9Install two alignment pins and place the left-side cover gasket into positionInstall the left-side coverNoting the different-lengthed
wllock washer to specificationsFront $1 Compression Oil Ring Expander End Gap ATV-I 0851 1NOTE: Note the direction of the
exhaust side of the piston (5) for correct ring end gap orientation BInstall the compression rings (1 and 2) so the letter
on the top surface of each ring faces the dome of the pistonRotate the rings until the ring end gaps are on directly opposite
sides of the piston according to the illustrationi NOTE: The chrome (silver) ring should be installed in the top position
11Tighten the cap screws (from step 9) in crisscross pattern to specifications12Place the gasket, recoil starter assembly,