2006 Arctic Cat ATVs factory service and repair manual, Page 173Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 173

CWhile holding the valve adjuster dial in place, use the valve adjuster handle and loosen the jam nut; then rotate the tappet
valveltappet clearance by 0.05 mm (0.002 in per mark 27Install the four top-side cap screws with rubber washers; then install
the remaining cap screwsTighten only until snug FWhile holding the adjuster dial at the proper clearance setting, tighten
the jam nut securely with the valve adjuster handle 30Place the two tappet covers with O-rings into position; then install
and tighten the cap screws securely 28In crisscross pattern starting from the center and working outward, tighten the cap
screws (from step 27) to specifications29Adjust valveltappet clearance using the following procedureUse Valve Clearance Adjuster
(pln 0444-078) for this procedure1NOTE: 31Install the spark plug and tighten to specifications; then install the timing inspection
plug ATurn the engine over until the piston reaches top-dead-center on the compression strokeBPlace the valve adjuster onto