2006 Arctic Cat ATVs factory service and repair manual, Page 186Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 186

BRemove each ring by working it toward the dome of the piston while rotating it out of the groove 1 1 B AT THIS POINT To
of components may be necessaryNote the AT THIS POINT information in each sub-sectionRemove the two cap screws securing the
speed sensor housing; then remove the housingAccount for the gasket and two seal washers 1 NOTE: The engineltransmission
does not have to be removed from the frame for this procedure Removing Left-Side Components ARecoil Starter BWater Pump CCover
DRotoriFlywheel 1Remove the four cap screws securing the recoil starter assembly to the left-side cover; then remove the
recoil starterAccount for the gasketB AT THIS POINT To service the recoil starter, see Servicing Left-Side Comonents sub-section
Loosen the clamps securing the coolant hose to the water pump; then remove the crossover tube from the cylinder headAccount