2006 Arctic Cat ATVs factory service and repair manual, Page 193Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 193

Disassembling Crankcase Half i NOTE: For steps 1-7, refer to illustration CC821B Secondary Driven Shaft Assembly Crank Balancer
driven shaft assembly (A) noting the location of the bearing locating pinsAccount for the bearing C-ring 3Remove the shift
shaft (H); then remove the two forks taking note of the direction of the tabs on the forks for assembling purposes 4Remove
the gear shift shaft (G) noting the location of the two holes on the end of the shaftAccount for two washers 2Remove the