2006 Arctic Cat ATVs factory service and repair manual, Page 194Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 194

5Remove the countershaft assembly (D)Account for washer on each end of the countershaft 8Remove the crank balancer1 NOTE:
snap ring securing the water pump driven gear shaft Using rubber tap remove the driveshaft the crankcase to 10Using hydraulic
press, remove the crankshaft assembly1 NOTE: Use protective end cap to prevent damage to the crankshaft threads Note the
alignment dots on the crank balancer assembly (B) gear and crankshaft (C) gear for assembling purposes; then slide the crank