2006 Arctic Cat ATVs factory service and repair manual, Page 197Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 197

ATV-1004 2Acceptable width range must be within specificationsMeasuring Valve Face Radial Runout 3Push the valve from side
be replaced ATVI 082A 3Rotate the valve in the blocks 1If valve guide needs replacing, insert valve guide remover into the
valve seat side of the valve guideUsing hammer, gently drive the valve guide out of the cylinder head 4Maximum runout must
not exceed specificationsMeasuring Valve GuideIValve Stem Deflection (Wobble Method) 1Mount dial indicator and base on the
surface plate; then place the cylinder head on the surface plate2Install the valve into the cylinder head; then position
the dial indicator contact point against the outside edge of the valve faceZero the indicator 2Using the Standard Valve Guide
Reamer (pln 0444-017), remove any burrs or tight areas from the valve guide journals Page: 197 Arctic Cat ATV 2006 -All Models