2006 Arctic Cat ATVs factory service and repair manual, Page 203Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 203

1 NOTE: To produce the proper 60' cross-hatch pattern, use low RPM drill (600 RPM) at the rate of 30 strokes per minuteIf
The trueness (out-of-roundness) is the difference between the highest and lowest readingMaximum trueness (out-of-roundness)
must not exceed specifications 4If any measurement exceeds the limit, replace the cylinder and pistonMeasuring Camshaft Runout
NOTE: Ifthe camshaft isout of tolerance, must it be replaced 1Place the camshaft on set of blocks; then position the dial
indicator contact point against the shaft and zero the indicator 2Wash the cylinder in parts-cleaning solvent3Inspect the
cylinder for pitting, scoring, scuffing, and corrosionIf marks are found, repair the surface using ball hone 2Rotate the
camshaft and note runout; maximum tolerance must not exceed specificationsMeasuring Camshaft Lobe Height 1Using calipers,