2006 Arctic Cat ATVs factory service and repair manual, Page 204Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 204

ATVI 013A 2The lobe heights must not exceed minimum specificationsInspecting Camshaft Bearing Journal 5Match the width of
and am nuts6If clearance is excessive, measure the journals of the camshaft 2Place strip of plasti-gauge in each of the camshaft
lands in the cylinder head 3Place the valve cover on the cylinder head and secure with the valve cover cap screwsTighten
securely1 NOTE: Do not rotate the camshaft when measuring clearance 1 NOTE: If the journals are worn, replace the camshaft;
then measure the clearance againIf it is still out of tolerance, replace the cylinder head 4Remove the cap screws securing