2006 Arctic Cat ATVs factory service and repair manual, Page 209Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 209

INSPECTING OIL PUMP 1Inspect the pump for damage2It is inadvisable to remove the screw securing the pump halvesIf the oil
then remove the wing nut, holding handle, flat washer, and pilot bushing leaving the large spacer on the compressor tool
base 4 Using suitable marking pen, make alignment marks on the fixed face spring holder and both pulley faces 5 Place the
holding handle on the spring holder A 2Place the driven pulley assembly onto the compressor tool base engaging the dowel
pins into appropriate holes in the fixed face of the assembly fitting the two dowel pins into the spring holder face; then