2006 Arctic Cat ATVs factory service and repair manual, Page 213Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 213

Servicing Center Crankcase Components H NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
must be removed for this procedureAlso, always start with the original shims on the rear shaft 1Place the left-side crankcase
cover onto the left-side crankcase half to prevent runout of the secondary transmission output shaft2Install the secondary
driven output shaft assembly onto the crankcase3Mount the dial indicator so the tip is contacting tooth on the secondary
driven bevel gear4While rocking the driven bevel gear back and forth, note the maximum backlash reading on the gauge 5Rotate
the secondary driven bevel gear several revolutions in both directions6Examine the tooth contact pattern in the dve and compare
the pattern to the llustrationsIncorrect (contact at tooth top) 5Acceptable backlash range is 0.05-0.33 mm (0.002-0.013 inCorrecting
Backlash H NOTE: If backlash measurement is within the acceptable range, no correction is necessary 1If backlash measurement