2006 Arctic Cat ATVs factory service and repair manual, Page 214Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 214

Correct Correcting Tooth Contact 2.Maximum diameter specifications rn NOTE: If tooth contact pattern is comparable to the
deflection must not exceed specificationsMeasuring Connecting Rod (Big End Side-to-side) NOTE: To correct tooth contact,
steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactShim Correction" chart must be
consulted After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue the correcting
backlashkorrecting tooth contact procedures until they are both within tolerance values 1Push the lower end of the connecting
rod to one side of the crankshaft journal2Using feeler gauge7 measure the gap between the connecting rod and crankshaft journal
CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting rod