2006 Arctic Cat ATVs factory service and repair manual, Page 215Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 215

Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod at the big-end bearing2Acceptable
gear dog2Remove the reverse gear dog; then remove the circlip securing the reverse driven gear3Remove the reverse driven
gear and account for the washer, bushing, and bearing Care should be taken to support the connecting rod when rotating the
crankshaft 4Maximum runout must not exceed specificationsH NOTE: Proceed to check runout on the other end of the crankshaft
by positioning the indicator contact at point and following steps 2-4 4Remove the low driven gear washer and lock washers;
then remove the low driven gearAccount for the bushing and bearing Measuring Crankshaft (Web-to-web) 5Remove the washer;
then remove the circlip securing the sliding dogRemove the sliding dog6Remove the high driven gear circlip; then remove the