2006 Arctic Cat ATVs factory service and repair manual, Page 219Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 219

7From the left side, install the eight case half 6 mm cap screws; then tighten only until snugiNOTE: Rotate the shafts back
(from steps 7-8) to specificationsI NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 11Using
liberal amount of grease, assemble the shift cam stoppers; then install them into the top of the engine4Using plastic mallet,
lightly tap the case halves together until cap screws can be installedI NOTE: The grease will hold the springs and cam stoppers
in position while installing the assemblies into the engine 5From the right side, install the mm cap screws; then tighten
only until snugINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6From the left side, install