2006 Arctic Cat ATVs factory service and repair manual, Page 222Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 222

16Place the V-belt into position on the driven pulley and over the front shaft 13Place the driven pulley assembly into position
coated with red Loctite #271)Tighten the nut to specifications 14Slide the fixed drive face onto the shaft15Spread the faces
of the driven pulley by pushing the inner face toward the engine while turning it counterclockwise; then when the faces are
separated, insert wedge (approximately 318 inthick) between the facesRelease the inner face1NOTE: At this point, the wedge