2006 Arctic Cat ATVs factory service and repair manual, Page 223Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 223

Place the V-belt cover gasket into position; then install the cover and secure with the cap screws making sure the different-lengthed
beveled side of the intermediate gear facing inward as noted in removing) 1Install the water pump drive gear alignment pin
and the drive gear (with the flat side of the gear facing outward as noted in removing); then secure with the snap ring 4In
order on the crankshaft, install washer, ring gear, key, and the magneto rotorSecure with the nut (threads coated with red
Loctite #271)Tighten to specifications5Lubricate the magneto cover gasket with fresh engine oil; then place it into position
on the two dowel pins 1 NOTE: The sharp side of the snap ring should be facing outward 2Install the water pump driven gear