2006 Arctic Cat ATVs factory service and repair manual, Page 224Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 224

6Install the magneto cover and secure with the cap screwsTighten only until snug7Place the starter cup into position on the
6) to specifications9Place the speed sensor housing and gasket into position and secure with thetwo cap screwsTighten securely
12Install the shift arm on the shift arm shaft making sure the scribed marks (from removing) are alignedTighten securely13Place
the gasket and recoil starter assembly into position on the left-side cover; then tighten four cap screws to specifications