2006 Arctic Cat ATVs factory service and repair manual, Page 245Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 245

8Using Side Case Puller (pln 0644-262), remove the side coverAccount for gasket, two alignment pins, and an idle gear limiter
their respective shafts for installing purposes 7Remove the fourteen cap screws securing the left-side cover to the crankcase
and note the location of the long cap screw with rubber washer ERotorFlywheel FIdle Gear Assembly i NOTE: Steps 1-8 in the
preceding sub-section must precede this procedure i NOTE: For steps 9-18, refer to illustration CD134B Output Shaft with