2006 Arctic Cat ATVs factory service and repair manual, Page 257Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 257

Table of Contents (Servicing Components) 1 NOTE: Critical enginetransmission specifications are located at the beginning
when resurfacing Servicing Top-Side Components 1 NOTE: Whenever part is worn excessively, cracked, or damaged in any way,
replacement is necessary Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or dam-
Removing Valves 1 NOTE: Keep all valves and valve components as setNote the original location of each valve set for use during
installationReturn each valve set to its original location during installation VALVE ASSEMBLY When servicing valve assembly,
inspect valve seats, valve stems, valve faces, and valve stem ends for pits, bum marks, or other signs of abnormal wear1
NOTE: Whenever valve is out of tolerance, it must be replaced 1Using valve spring compressor, compress the valve springs
and remove the valve cottersAccount for an upper spring retainer CleaningflnspectingValve Cover 1 NOTE: If the valve cover
cannot be trued, the cylinder head assembly must be replaced 1Wash the valve cover in parts-cleaning solvent Page: 257 Arctic