2006 Arctic Cat ATVs factory service and repair manual, Page 265Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 265

2The lobe heights must not exceed minimum specificationsInspecting Camshaft Bearing Journal 1Inspect the bearing journal
screws and am nuts 1Place the camshaft on set of blocks; then position the dial indicator contact point against the shaft
and zero the indicator 2Place strip of plasti-gauge in each of the camshaft lands in the cylinder head3Place the valve cover
on the cylinder head and secure with the valve cover cap screwsTighten securelyCC283D 1 NOTE: Do not rotate the camshaft
when measur- 2Rotate the camshaft and note runout; maximum tolerance must not exceed specificationsMeasuring Camshaft Lobe