2006 Arctic Cat ATVs factory service and repair manual, Page 268Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 268

Cleaning and Inspecting 1 NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
then untie the knot in the rope and remove the handle1 NOTE: Do not remove the spiral spring unless replacement is necessaryIt
should be visually inspected in place to save timeIf replacement is necessary, follow steps 9-10 9Remove the spiral spring
from the case by lifting the spring end up and outHold the remainder of the spring with thumbs and alternately release each
thumb to allow the spring to gradually release from the case 2Insert the rope through the hole in the reel and tie knot in
the end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel3Apply
low-temperature grease to the spring and hub 10Unwind the rope from the reel and remove the rope 4Thread the end of the rope
through the guide hole of the case; then thread the rope through the handle and secure it with double knotInstall the protective