2006 Arctic Cat ATVs factory service and repair manual, Page 273Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 273

SECONDARY GEARS H NOTE: When checking and correcting secondary gear backlash and tooth contact, the universal joint must
W NOTE: If backlash measurement is within the acceptable range, no correction is necessary W NOTE: The primary clutch assembly
is now completely assembled for installation INSPECTING OIL PUMP 1Inspect the pump for damage 2It is inadvisable to remove
the screw securing the pump halvesIf the oil pump is damaged, it must be replaced 1If backlash measurement is less than specified,
remove an existing shim7measure it, and install new thinner shim 2If backlash measurement is more than specified, remove
an existing shim, measure it, and install thicker shimW NOTE: Continue to remove, measure, and install until backlash measurement
is within toleranceNote the following chartServicing Center Crankcase Components NOTE: Whenever part is worn excessively,
cracked, damaged in any way, or out of tolerance, replacement is necessaryW Backlash Measurement Under 0.05 mm (0.002 in