2006 Arctic Cat ATVs factory service and repair manual, Page 274Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 274

1Remove the secondary driven output shaft assembly from the left-side crankcase half2Clean the secondary driven bevel gear
contact, steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactShim Correction" chart
must be consulted A CAUTION After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue
the correcting backlashcorrecting tooth contact procedures until they are both within tolerance values CRANKSHAFT ASSEMBLY
Measuring Connecting Rod (Small End Inside Diameter) Incorrect (contact at tooth root) 1Insert snap gauge into the upper
connecting rod small end bore; then remove the gauge and measure it with micrometer Correct 2Maximum diameter must not exceed
specificationsMeasuring Connecting Rod (Small End Deflection) 1Place the crankshaft on set of V-blocks and mount dial indicator
and base on the surface platePosition the indicator contact point against the center of the connecting rod small end journalPage: