2006 Arctic Cat ATVs factory service and repair manual, Page 288Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 288

7In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 3-4) until the halves are correctly joined; then
crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side Components, and to In- stalling
Top-Side Components Installing Right-Side Components AOil StrainerIOil Pump BGear Shift Shaft 3Place the oil pump into position
in the crankcase and secure with the three Phillips-head screws coated with blue Loctite #243Tighten to specifications 1Place
the oil strainer into position beneath the crankcase and tighten securely with the Phillips-head cap screws 4Place the pin
and washer into position on the oil pump shaft, install the oil pump driven gear, and secure with the circlip Page: 288 Arctic