2006 Arctic Cat ATVs factory service and repair manual, Page 290Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 290

I 'EX The clutch sleeve hub and the pressure plate must be seated in the proper positionIf any of the incorrect positions
in the primary assembly 9Place the chain into the crankcase; then secure it from the top side with wire for ease of assembling
i NOTE: Note the alignment mark scribed on the primary driven gear assembly during disassembly 10Install the primary driven
washers onto the driveshaft and crankshaft 12Using the Clutch Sleeve Hub Holder (pln 0444-007), install the nut and washerTighten