2006 Arctic Cat ATVs factory service and repair manual, Page 293Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 293

2Place the shift-indicator sending unit into position making sure the contacts and springs are inside the case and well-oiled
the starter idle gear pin into the crankcase; then with the beveled side of the idle gear facing the crankcase, install the
idle gear spacer ing and driveshaft alignIf they are not aligned, major damage will occur from lack of lubrication 4Place
the bushing onto the output shaft; then install the driven gear and washer 7In turn on the driveshaft, install the #l drive