2006 Arctic Cat ATVs factory service and repair manual, Page 297Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 297

26Install the inside circlip onto the hillow range shift shaft with the sharp side of the circlip facing the engine; then
the shift shaftSecure with the outer circlip making sure the sharp side of the circlip faces away from the hillow-range lever
1 NOTE: If the piston rings were removed, install them in this sequence AInstall ring expander (4) in the bottom groove of
the piston; then install the thin oil rings (3) over the expander making sure the expander ends do overlap# Compression Ring
End Gap S3 Thin 01 Ring En Gap Compression Ring End Gap 28Place the recoil starter assembly into position on the left-side