2006 Arctic Cat ATVs factory service and repair manual, Page 299Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 299

5Install the coolant hose onto the crankcase union and tighten the clampCCylinder Head DValve Cover EY 1Cylinder Head Assy
Cover 31Thermostat 'Frost Plug 'Not Illustrated i NOTE: Steps 1-5 in the preceding sub-section must precede this procedure
6Place the chain guide into the cylinder.1 Care should be taken that the bottom of the chain auide is secured in the crankcase
boss 7Place the head gasket into position on the cylinderPlace the alignment pins into position; then place the head assembly
into position on the cylinder 8Install the four cylinder head cap screws with copper washers (note the locations of the different-lengthed