2006 Arctic Cat ATVs factory service and repair manual, Page 300Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 300

9Loosely install the five cylinder head nuts 1 NOTE: At this point, oil the camshaft bearings, cam lobes, and the three seating
(from step 4) securely11With the timing inspection plug removed and the chain held tight, rotate the crankshaft until the
piston is at top-dead-center12With the alignment pin installed in the camshaft, loosely place the cam sprocket (with the
recessed side facing the cam shaft lobes) onto the camshaftAt this point, do not "seat" the sprocket onto the shaft 1 NOTE:
Note the position of the alignment marks on the end of the camshaftThey must be parallel with the valve cover mating surfaceIf
rotating the camshaft is necessary for alignment, do not allow the chain and sprocket to rotate and be sure the cam lobes