2006 Arctic Cat ATVs factory service and repair manual, Page 303Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 303

29In crisscross pattern starting from the center and working outward, tighten the cap screws (from step 28) securely30Adjust
cover CWhile holding the valve adjuster dial in place, use the valve adjuster handle and loosen the jam nut; then rotate
the tappet adjuster screw clockwise until friction is felt27Place the valve cover into position=NOTE: At this point, the
rocker arms and adjuster screws must not have pressure on them DAlign the valve adjuster handle with one of the marks on
the valve adjuster dialEWhile holding the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise
until specified valveltappet clearance is attained1 NOTE: Rotating the valve adjuster dial counterclockwise will open the
valveltappet clearance by 0.05 mm (0.002 in per mark 28Install the four top side valve cover cap screws with rubber washers;